When running tests manually from Spira you can create an Incident when a test fails and get a trace back to test case from the incident. I.e when Incident is correcte you will know which test case you should re-run. Now when we run the test cases automatically in a test set by using RemoteLaunch we will get some failed Test Runs. After analyze we will create an Incident report but we can not find a way to connect the incident to the Test Run. Is there a way to create a realation between a failed Test Run and an Incident report? en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/remotelaunch/issues-questions/853.aspxthreadId=853Peter Kaltenbrunner (peter.kaltenbrunner@ascom.se)test runs incidents When running tests manually from Spira you can create an Incident when a test fails and get a trace back to test case from the incident. I.e when Incident is correcte you will know which test case you should re-run. Now when we run the test cases automatically in a test set by using RemoteLaunch we will get some failed Test Runs. After analyze we will create an Incident report but we can not find a way to connect the incident to the Test Run. Is there a way to create a realation between a failed Test Run and an Incident report? Wed, 05 Mar 2014 12:33:09 -05002014-03-06T16:43:39-05:00/Support/Forum/remotelaunch/issues-questions/853.aspxmessageId=1557Inflectra Sarah (donotreply6@kronodesk.net) Hi Peter There is not a way to link an existing incident to an existing test run I'm afraid. You can link an existing incident to an existing test step however. Regards Sarah Thu, 06 Mar 2014 16:43:39 -05002014-03-06T16:43:39-05:00/Support/Forum/remotelaunch/issues-questions/853.aspx#reply1557