Inflectra Customer Forums: Test Set Total Execution Time (Thread) Is there a way to track the total execution time when a test set is executed via Remote Launch? We are using RemoteLaunch with ReadyAPI Pro and the execution times appear to be very slow. We are ramping up the number of test cases in our automated test suite and would like to track the total execution time each time the test set is run. en-US(C) Copyright 2006-2026 Inflectra Corporation.support@inflectra.com/Computers/Software/Project_Management//Computers/Software/Quality_Assurance/KronoDesksupport@inflectra.comhttp://www.inflectra.com/kronodesk/forums/threads120/Support/Forum/remotelaunch/issues-questions/2736.aspxthreadId=2736Mitch Washburn (mitchell.washburn@gdit.com)remotelaunch readyapiTest Set Total Execution Time Is there a way to track the total execution time when a test set is executed via Remote Launch? We are using RemoteLaunch with ReadyAPI Pro and the execution times appear to be very slow. We are ramping up the number of test cases in our automated test suite and would like to track the total execution time each time the test set is run. Thu, 29 Dec 2022 15:35:44 -05002023-01-03T17:25:07-05:00/Support/Forum/remotelaunch/issues-questions/2736.aspxmessageId=5832David J (adam.sandman+support@inflectra.com) Hi Mitchell Go to Testing > Test Sets. Then make sure you do Show Columns > Show Act. Dur (actual Hi Mitchell Go to Testing > Test Sets. Then make sure you do Show Columns > Show Act. Dur (actual duration) Regards David Thu, 29 Dec 2022 17:43:05 -05002022-12-29T17:43:18-05:00/Support/Forum/remotelaunch/issues-questions/2736.aspx#reply5832messageId=5834Mitch Washburn (mitchell.washburn@gdit.com) Thank you. Is there a way to show the duration in ms? Our test set duration just says 0.0h but Thank you. Is there a way to show the duration in ms? Our test set duration just says 0.0h but when I look at the actual timestamps of when each test case ran, the full test set took more than 3 minutes to run (for just 6 test cases). We are executing API test cases and are using ReadyAPI pro as our automation engine. The same number of test cases would have only taken seconds to executed through the ReadyAPI client. Are there instructions on how to best setup API test cases for Remote Launch? Eventually, we have 1,000+ test cases so the performance will be an issue if each case takes 30 seconds to complete. Tue, 03 Jan 2023 17:25:07 -05002023-01-03T17:25:07-05:00/Support/Forum/remotelaunch/issues-questions/2736.aspx#reply5834